LATEST ALL IN ONE FULLY ADJUSTABLE 40+BHP POWER CHIP WITH FUEL SAVE OPTION
Works on all MINI Cooper S vehicles.
This device will allow you to adjust the power output of your vehicles engine without sacrificing reliability or comfort, and then reduce it down to a point where it becomes the best fuel saver available today. This hi tech mod connects to your vehicles inlet air temperature sensor wires, unlike other performance chips you do not have to open up the main processing unit (the ECU) to fit. You will feel the gain instantly, no expensive tuning necessary.
- 100% adjustable, just select what suits you from the fuel saving 'ECO' setting right up to the '40 BHP' setting.
- Can be dash mounted using the 2 meter cable option at the bottom of this page.
- Works on all electronic fuel injected petrol, diesel, lpg, turbocharged and supercharged vehicles.
- Very tough and robust device that will last for years.
- Comes with detailed universal fitting instructions with photos that apply to every vehicle.
- This device connects to the IAT (inlet air temp) sensor using simple easy to use connectors, the IAT sensor is normally built into the MAF sensor near the air filter on cars made after 2000, before 2000 it is usually on a seperate 2 wire plug, make sure you can locate this before buying.
BHP GAIN : ACCORDING TO THE MANUFACTURER'S INFO, THIS UNIT WILL HELP YOUR VEHICLE GAIN AN EXTRA 40 BHP SOMETIMES MORE DEPENDING ON THE SETTING YOU CHOOSE AND THE POTENTIAL OF YOUR VEHICLE ENGINE. THE MORE BHP YOUR VEHICLE PRODUCES THE MORE BHP IT WILL GAIN FROM THIS UNIT.
Frequently Asked Questions :
Q. What is the difference between this device and more expensive performance chips ?
A. Performance eprom chips such as the ones from Superchips, BBR Starchip etc consist of a stock computer program that has been altered to inject more fuel into the engine under acceleration. Timing curves are commonly also adjusted consequently. These chips can be found to be quite effective, but are also very expensive - costing normally from 200 to 1500 pounds ! they also require plenty of time, specialist tools and occasionally soldering to fit. Our 'piggy back' device on the other hand will alter the fuel and timing curves in a very similar way to the eprom chip for a fraction of the cost, without even having to open the ECU.
Q. What is an ECU ?
A. An ECU is a computer that manages your vehicles engine and keeps it running. It received data from the different sensors on the engine and reacts consequently, adjusting the level of fuel injected in the engine as well as the timing advance.
Q. What is a 'piggy back' device ?
A. A piggy back device is a device meant to externally alter one or more signals sent to the vehicles ECU. This is a very common thing to do but also very expensive. Most piggy back devices cost a few hundred pounds.
Q. Will my Vehicle accelerate faster with this electronic device?
A. Yes! This is the latest fully adjustable all in one power mod/fuel saver and when adjusted for more power it has been dyno proven on various Rolling Roads across the country to add up to 40+BHP to your car !
Q. Will this device damage my Vehicle ?
A. Absolutely not. Since the altered signal will always stay within cars specifications, there is no way for your engine to get damaged in any way.
Q. How hard is it to install this device to my Vehicle ?
A. Installation on all car models is a very simple task that can usually be completed within 5 minutes. Full step by step instructions are included.
Q. Do I need any special skills or tools ?
A. Just some pliers to fit the connectors securely and maybe a voltmeter for MAF sensor fitting on 2000-on vehicles.
Q. Will this improve my fuel consumption ?
A. Yes! This is the latest fully adjustable all in one fuel saver/power mod on the market today and tests have proven that when the device is set to economy/low power, fuel consumption has been reduced in most cases - More power & more MPG !